Ignition & Key Alarm Switch - Disassemble

DISASSEMBLY PROCEDURE





1. Remove the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Disassemble -Off Vehicle (Column Shift).
2. Remove the wire harness assembly (1) from the steering column and the wire harness strap (2).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





4. Rotate the key alarm connector (1) 90 degrees.
5. Pull the key alarm connector (1) out of the lock module assembly (2).
6. Remove the passkey connector from the lock module assembly (2).





7. Slide the ignition and key alarm switch assembly (2) out of the lock module assembly (1).