Fuel Injector Replacement

REMOVAL PROCEDURE

NOTE: Use care in removing the fuel injectors to prevent damage to the electrical connector terminals, the injector filter, and the fuel nozzle.

The fuel injector is serviced as a complete assembly only.

Also since the injectors are electrical components, these injectors should not be immersed in any type of liquid solvent or cleaner as damage may occur.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure.
3. Remove the Upper Manifold Assembly.
4. Remove the Fuel Meter Body Assembly.

INSTALLATION PROCEDURE
1. Install the fuel meter body assembly.
2. Install the upper manifold assembly.
3. Connect the negative battery cable.
4. Turn the ignition On for 2 seconds.
5. Turn the ignition Off for 2 seconds.
6. Turn the ignition On for 2 seconds.
7. Inspect for fuel leaks.