Rear

^ Tools Required
- J 6627-A Wheel Stud Remover

Removal Procedure





1. Raise the vehicle on a hoist and allow the axle to hang free. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
3. Remove the drum or rotor. Refer to Brake Rotor Replacement - Rear in Disc Brake Systems.
4. Use the J 6627-A in order to remove the stud from the axle flange.

Installation Procedure
1. Start the new stud into the axle flange hole by pressing firmly with your hand.
2. Thread the lug nut on the stud with the flat side of the lug nut to the vehicle.
3. Tighten the lug nut in order to draw the stud into the rear of the flange.
4. Thread the lug nut off the stud.
5. Install the drum or rotor. Refer to Brake Rotor Replacement - Rear in Disc Brake Systems.
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
7. Lower the vehicle.