Vacuum Solenoid Valve HVAC: Service and Repair

HVAC SYSTEM - MANUAL


REMOVAL PROCEDURE




1. Remove the instrument panel carrier.
2. Disconnect the electrical connector from the vacuum electrical control solenoid.
3. Disconnect the vacuum harness connectors from the vacuum electrical control solenoid.




4. Remove the vacuum electrical control solenoid retaining screws.
5. Remove the vacuum electrical control solenoid from the vehicle.

INSTALLATION PROCEDURE




1. Install the vacuum electrical control solenoid to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the vacuum electrical control solenoid retaining screws.

Tighten
Tighten the vacuum electrical control solenoid retaining screws to 1.9 N.m (17 lb in).




3. Connect the vacuum harness connectors to the vacuum electrical control solenoid.
4. Connect the electrical connector to the vacuum electrical control solenoid.
5. Install the instrument panel carrier.