Clutch Rotor and/or Bearing Removal (V7 - Direct Mount)

TOOLS REQUIRED
^ J 33023-A Puller Pilot
^ J 41552 Compressor Pulley Puller
^ J 41790 Compressor Holding Fixture




1. Remove the compressor from the vehicle.
2. Clamp the compressor holding fixture, J41790 in a vise and attach the compressor to the J 41790.
3. Remove the clutch plate and hub assembly.
4. Using external snap ring pliers (1), remove the clutch rotor and bearing assembly retaining ring (3).




5. Place the J 33023-A on the clutch rotor.




6. Install the J 41552 down into the inner circle of slots in the rotor.
Turn the J 41552 clockwise in the slots to engage the puller tangs with the rotor.
7. Hold the J 41552 in place and use a wrench to turn the center forcing screw against the J 33023-A to remove the clutch rotor and bearing assembly.