FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Chevy Truck >> 1999 >> S10/T10 P/U 4WD V6-4.3L VIN X >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Drive Belts, Mounts, Brackets and Accessories >> Engine Accessory Bracket >> Service and Repair >> PS Pump Mounting Bracket Replacement

PS Pump Mounting Bracket Replacement

Removal Procedure





1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement in Powertrain Management.
2. Remove the engine cooling fan. Refer to Fan Clutch Replacement in Cooling System.
3. Remove the drive belt. Refer to Drive Belt Replacement.

Important: Do not evacuate the air conditioning system.

4. Remove the mounting bolts for the Air Conditioning (A/C) compressor, if equipped.
5. Move the A/C compressor aside and support.
6. Remove the drive belt idler pulley if not equipped with A/C. Refer to Drive Belt Idler Pulley Replacement (Without A/C).
7. Remove the power steering pump pulley. Refer to Power Steering Pump Replacement in Steering and Suspension.





8. Remove the three bolts holding the power steering pump to the power steering pump mounting bracket.





9. Remove the three bolts and nut holding the power steering pump mounting bracket to the engine.
10. Slide the bracket off the power steering mounting bracket stud and power steering pump.

Installation Procedure





1. Slide the power steering pump mounting bracket onto the stud and the power steering pump.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the power steering pump mounting bracket three bolts and the nut.
^ Tighten the power steering pump mounting bracket bolts and nut to 41 Nm (30 ft. lbs.).





3. Install the three bolts for the power steering pump.
^ Tighten the power steering pump to power steering pump mounting bracket bolts to 50 Nm (37 ft. lbs.).
4. Install the power steering pump pulley. Refer to Power Steering Pump Replacement in Steering and Suspension.
5. Install the air conditioning compressor, if equipped. Refer to Compressor Replacement in Heating and Air Conditioning.
6. Install the drive belt idler pulley if not equipped with A/C. Refer to Drive Belt Idler Pulley Replacement (Without A/C).
7. Install the drive belt. Refer to Drive Belt Replacement.
8. Install the engine cooling fan. Refer to Fan Clutch Replacement in Cooling System.
9. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement in Powertrain Management.
pro multis Credits:Operation CHARM About Operation CHARM