Generator Mounting Bracket Replacement

Removal Procedure





1. Disconnect the battery negative cable. Refer to Battery Replacement in Starting and Charging.
2. Remove the engine cooling fan. Refer to Fan Clutch Replacement in Cooling System.
3. Remove the drive belt. Refer to Drive Belt Replacement.
4. Remove the generator. Refer to Generator Replacement in Starting and Charging.
5. Remove the engine wiring harness bracket from the generator mounting bracket.
6. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement
7. Remove the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement (Right).





8. Remove the three bolts and nut holding the generator mounting bracket to the engine.
9. Slide the generator mounting bracket off of the stud.

Installation Procedure





1. Slide the generator mounting bracket onto the stud.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the two generator mounting bracket bolts and the nut.
^ Tighten the generator mounting bracket bolts and nut to 41 Nm (30 ft. lbs.).
3. Install the drive belt idler pulley. Refer to Drive Belt Replacement
4. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement





5. Install the engine wiring harness bracket to the generator mounting bracket.
^ Tighten the engine wiring harness bracket bolt to 25 Nm (18 ft. lbs.).
6. Install the generator. Refer to Generator Replacement in Starting and Charging.
7. Install the drive belt. Refer to Drive Belt Replacement
8. Install the engine cooling fan. Refer to Fan Clutch Replacement in Cooling System.
9. Connect the battery negative cable. Refer to Battery Replacement in Starting and Charging.