Brake Hose Replacement - Rear

Removal Procedure
1. Raise and suitably support the vehicle.





2. Disconnect the brake pipe fittings.





3. Remove the retainer.
4. Remove the rear flex hose to bracket bolt.
5. Remove the rear flex hose.

Installation Procedure

Important: After installation, ensure that the rear flex hose is not twisted and that the rear flex hose does not contact any of the other components.





1. Install the rear flex hose.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the rear flex hose to bracket bolt.
Tighten the bolt to 17 Nm (13 ft. lbs.).
3. Install the retainer.





4. Connect the brake pipe fittings.
Tighten the brake pipe fittings to 17 Nm (13 ft. lbs.).
Bleed the brakes.
5. Remove the safety stands and lower the vehicle.