Backing Plate: Service and Repair

Removal Procedure





1. Remove the brake shoes.
2. Remove the wheel cylinder.
3. Remove the axle shaft.
4. Remove four bolts and washers.
5. Remove the backing plate.

Installation Procedure





1. Install the backing plate.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install four bolts and washers.
Tighten the backing plate mounting bolts to 48 Nm (35 ft. lbs.).
3. Install the axle shaft.
4. Install the wheel cylinder.
5. Install the brake shoes.
6. Bleed the brake system.