Brake Pads Replacement - Front (Dual Piston Caliper)

Removal Procedure
Use GM replacement brake lining material for this vehicle. GM replacement brake parts provide the proper brake balance for stopping distance and for braking control. The intended brake balance for this vehicle can change if GM replacement brake lining materials are not used.





1. Remove two-thirds of the brake fluid from the master cylinder reservoir.

Important: Do not disconnect the brake hose from the caliper.

2. Remove the caliper.

Notice: Do not allow the brake components to hang from the flexible brake hoses. Damage to the brake hoses could result.





3. Suspend the caliper.
4. Remove the pads from the caliper bracket.

Installation Procedure

Caution: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in personal injury.

Important: Before installing new brake pads, wipe the outside surface of the caliper boot clean. Use denatured alcohol.





1. Install the pads to the caliper bracket.
2. Verify that all 4 of the wear sensors are in place.

Notice: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.

3. Install the caliper.
4. Burnish the new brake pads.