Headlining Trim Panel Replacement (Utility)

Headlining Trim Panel Replacement (Utility)

Caution: Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material is damaged, replace the headliner and/or the garnish trim. Failure to do so could result in personal injury.

Removal Procedure




1. Remove the sunroof console, if equipped.
2. Remove the dome lamp.
3. Remove the sunroof opening trim, if equipped, by grasping it at the edge and pulling it away from the headliner.
4. Remove the coat hooks.
5. Remove the assist handles.
6. Remove the sunshades and the retainers.
7. Remove the windshield garnish moldings.
8. Remove the body lock pillar trim panels (4-door models only).




9. Remove the upper seat belt anchor bolts (2-door models only).




10. Remove the inside air temperature sensor grille.
11. Remove the body side trim panel.
12. Remove the rear upper garnish molding.
13. Remove the headliner from the vehicle.

Installation Procedure




1. Install the headliner to the vehicle. New headliners must be pierced in order to accommodate actual vehicle accessories.
2. Install the rear upper garnish molding.
3. Install the upper body side panel trim.
4. Install the inside air temperature sensor grille.





Notice: Refer to Fastener Notice.

5. Install the rear seat upper seat belt anchor bolts (2-door models only).

Tighten the bolts to 70 N.m (52 lb ft).




6. Install the body lock pillar trim panels (4-door models only).
7. Install the windshield garnish moldings.
8. Install the sunshades and the retainers.
9. Install the assist handles.
10. Install the coat hooks.
11. Install the sunroof opening trim, if equipped, by carefully pressing it into place.
12. Install the dome lamp, if equipped.
13. Install the overhead or sunroof console, if equipped.