Canister Purge Solenoid: Service and Repair

REMOVAL PROCEDURE





CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Disconnect the [1][2]EVAP purge line.




3. Disconnect the purge solenoid electrical connector.




4. Remove the purge solenoid mounting nuts.
5. Remove the engine wiring harness bracket from the mounting stud.




6. Remove the purge solenoid from the intake manifold.

INSTALLATION PROCEDURE




1. Install the purge solenoid to the intake manifold.
2. Install the engine wiring harness bracket to the mounting stud.





NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the purge solenoid mounting nuts.

Tighten
Tighten the bolts to 12 N.m (106 lb in).




4. Connect the purge solenoid electrical connector.




5. Connect the [1][2]EVAP purge line.
6. Connect the negative battery cable.