Drive End Housing Bushing

REMOVAL




1. Inspect the drive end housing bushing (9) in order to verify it the drive end housing bushing needs replacement.
2. Use the following procedure in order to remove the drive end housing bushing (9) from the drive end housing (7) if the drive end housing bushing needs replacement.
2.1. Drive out the plug, if present, from inside the drive housing.
2.2. Use a tile in order to clean away any remnants of the old stake and any metal shavings in order to prepare for installation of a new plug.
2.3. Use a suitable tool in order to press out the bushing.

INSTALLATION




1. Use a suitable tool in order to press the new bushing into the drive housing until the bushing is flush with the inside of the housing.
2. Install a new plug, if used, in the drive housing.
3. Stake the housing material over the plug at 3 places, equally spaced.