Parking Brake Pedal: Adjustments

PIN UP PROCEDURE
Before any components of the parking brake system are replaced, the following Pin Up procedures must be followed.
1. Remove the left kick panel.
2. Place the parking brake lever in the FULL upward position.
3. With one person in the vehicle, raise and support the vehicle.





4. With the second person, pull rearward on the front cable strand until the parking brake lever drum (2) reaches its full reset position (3).
5. Insert a scribe or nail (1) into the parking brake lever to hold the tension to its full reset position.
6. Remove the part that requires service.