Center Support and Gear Unit Assembly Installation

^ Tools Required
- J 38868 Gear Unit Assembly Installer/Remover
- J 6129 Handle
- J 28585 Snap Ring Remover/Installer





1. Attach the J 38868 and J 6129 onto the main shaft (662).
2. Align the bolt hole in the center support with the bolt hole in the case and carefully lower the gear unit assembly (640-672) into the case.
3. Remove the tools.





4. Install the center support retaining ring (633) using J28585. The end gap should be located at the nine o'clock position with the beveled edge of the snap ring facing up.