Starter Motor Overhaul (28-MT Reduction and Drive Disa)

Frame, Field, And Brush Holder Group:

1. Disassemble the insulated brush screws. Move the brush holder assembly with the brushes slightly away from the frame and the field assembly to reach across with a screwdriver and remove the screws.
2. Disassemble the frame and the field assembly.
3. Disassemble the grounded brush screws.
4. Disassemble the brushes if they need replacement.
5. Disassemble the brush springs using the following procedure:
^ Grasp the brush end of each brush spring with needle nose pliers.
^ Twist the spring end away from the brush.
^ Remove the brush.