Disassemble and Assemble

DISASSEMBLE PROCEDURE
1. Disassemble the lower hold down plate and nuts.
2. While pulling the poppet nozzle tube downward, push with small screwdriver down between the injector terminals until the injector is removed.

ASSEMBLE PROCEDURE

NOTE: Each injector is calibrated for a specific flow rate. When replacing fuel injectors, order the correct injector for the application being serviced.

1. Lubricate the new injector O-ring seals with clean engine oil.
2. Install on the injector assembly.
3. Assemble the Central SFI fuel injector assembly into the fuel meter body injector socket.
4. Assemble the lower hold down plate and nuts.

Tighten
- Tighten the nuts to 3.0 Nm (27 lb. in.).