Pressure Control Solenoid

Control Valve Body:

Fig. 1

Control Valve Body (Key):

Fig. 2

Transmission Wiring Diagram 4L60-E:

Fig. 3 - Wiring Diagram


Remove or Disconnect

1. Negative (-) battery cable.

^ Raise vehicle and suitably support.

^ Place drain pan under transmission oil pan.

2. Refer to "Changing Fluid and Filter".

3. Electrical connections from pressure control solenoid.

4. Pressure control solenoid retainer bolt (364) retainer (378) and solenoid (377).

Install or Connect

1. Pressure control solenoid retainer bolt (364) retainer (378) and solenoid (377).

Tighten

^ Bolt to 11 N.m (8 ft. lbs.)

2. Wiring harness connections to pressure control solenoid.

Note The pressure control solenoid (377) has two different colored connectors. The black connector should be installed on the tab farthest from the valve body.

3. New filter with seal. Pan gasket, pan bolts and new fluid.

4. Refer to "Changing Fluid and Filter."

5. Lower vehicle.

6. Negative (-) battery cable.

Adjust

^ Fluid level, Refer to "Transmission Fluid Checking Procedure".

^ DEXRON� IIE Automatic Transmission Fluid. Inspect for leaks.