Three Speed Shift Linkage Adjust

Fig. 6 Three speed column shift linkage adjustment.C, K, R & V models:

Fig. 7 Three speed column shift linkage adjustment. G & P models:

SERIES 10---30/1500---3500
Column Shift
1. Position transmission lever B (C, K, R and V models) or C (G and P models) clockwise to forward detent, Figs. 6 and 7, then turn ignition switch to ``LOCK.''
2. Remove column lash by rotating lever J (C, K, R and V models) or L (G and P models) downward and tightening bolt C (C, K, R and V models) or M (G and P models).
3. Turn ignition switch to ``UNLOCK,'' then position transmission levers in Neutral. To position levers in Neutral, move levers B and E (C, K, R and V models) or B and C (G and P models) to forward detent, then turn counterclockwise one detent, Figs. 6 and 7.
4. Align gage pin holes in levers H, J and K (C, K, R and V models) or G, H, and L (G and P models), then insert gage pin.
5. Repeat Step 2 for rod F (C, K, R and V models) or E (G and P models) and levers E and H (C, K, R and V models) or B and G (G and P) models).
6. Remove gage pin.
7. Place column lever in Reverse and check interlock control. Ignition should lock only when in Reverse.