Manual Shaft, Range Selector Inner Lever & Parking Linkage

1. Remove oil pan and strainer.

2. Remove manual shaft to case retainer and unthread jam nut holding range selector inner lever to manual shaft.

3. Remove jam nut and remove manual shaft from range selector inner lever and case. Do not remove manual shaft lip oil seal unless replacement is required.

4. Disconnect parking pawl actuating rod from range selector inner lever and remove both from case.

5. Remove bolts and parking lock bracket

6. Remove parking pawl disengaging spring.

7. If necessary to replace parking pawl or shaft, clean up bore in case and remove parking pawl shaft retaining plug, parking pawl shaft and pawl.