Brake Control Brake Pedal Position Sensor Replacement

Brake Control Brake Pedal Position Sensor Replacement

Removal Procedure

1. Disconnect the brake control brake pedal position sensor electrical connector.





2. Remove the brake control brake pedal position sensor bolt (1).





3. Remove the brake control brake pedal position sensor (1).

Installation Procedure





1. Align the locating pin on the brake control brake pedal position sensor (1) to the hole on the brake pedal assembly bracket.

2. Ensure the brake control brake pedal position sensor fork is properly located on the brake pedal pin.





Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the brake control brake pedal position sensor bolt (1) and tighten to 9 Nm (80 lb in).

4. Connect the brake control brake pedal position sensor electrical connector.

5. Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle.