U180C

DTC U180C

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC U180C
- Battery Charger Control Module High Speed CAN Bus Off

For symptom byte information, refer to Symptom Byte List Symptom Byte List.

Circuit/System Description

The high speed GMLAN serial data circuits are serial data buses used to communicate information between the devices. The high speed GMLAN serial data circuits also connect directly to the data link connector (DLC) for programming purposes.

Conditions for Running the DTC

* Supply voltage to the devices are in the normal operating range.

* The vehicle power mode requires serial data communications.

Conditions for Setting the DTC

The device setting the DTC has attempted to establish communications on the high speed GMLAN serial data circuits more than 3 times.

Action Taken When the DTC Sets

DTC U180C is a type B DTC.

Conditions for Clearing the DTC

DTC U180C is a type B DTC.

Circuit/System Verification

1. Vehicle in Service Mode.

2. Verify DTC U180C is not set.

• If DTC U180C is set
Refer to Scan Tool Does Not Communicate with High Speed GMLAN Device Scan Tool Does Not Communicate with High Speed GMLAN Device.

• If DTC U180C is not set

3. All OK