Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor Replacement

Removal Procedure





Note:
Graphic shows exhaust camshaft position sensor. Use same procedure for Intake camshaft position sensor.

1. Disconnect the camshaft position sensor wiring harness plug (1).





Note:
Graphic shows exhaust camshaft position sensor. Use same procedure for Intake camshaft position sensor.

2. Remove the camshaft position sensor bolt (3).

3. Remove the camshaft position sensor (2) and the seal ring (1).

Installation Procedure





Note:
Graphic shows exhaust camshaft position sensor. Use same procedure for Intake camshaft position sensor.

1. Install the camshaft position sensor (2) and the seal ring (1).

Caution:
Refer to Fastener Caution Fastener Caution

2. Install the camshaft position sensor bolt (3) and tighten to 8 Nm (71 lb in).





Note:
Graphic shows exhaust camshaft position sensor. Use same procedure for Intake camshaft position sensor.

3. Connect the camshaft position sensor wiring harness plug (1).

4. After replacement of an camshaft position sensor, use a scan tool to speed up learn function. Refer to Engine Control Module Programming and Setup Testing and Inspection