Warm Up Three-Way Catalytic Converter Installation

Warm Up Three-Way Catalytic Converter Installation





1. Install the warm up three way catalytic converter (5) to the brackets and the turbocharger. Use a NEW warm up three way catalytic converter seal (2).

Note:
Never re-use the V-clamp.

2. Install a NEW warm up three way catalytic converter V-clamp (1).

3. Install the 2 catalytic converter to catalytic converter bracket nuts (4) and (6) and hand tighten.

4. Hand tighten the catalytic converter V-clamp.

5. Connect the heated oxygen sensor wiring harness (3) to retainer clip.





6. The catalytic converter V-clamp (1) should be installed in the shown position.

Caution:
Refer to Fastener Caution Fastener Caution.

7. Tighten the catalytic converter to catalytic converter bracket nuts to 22 Nm (16 lb ft).

8. Tighten the catalytic converter V-clamp to 13 Nm (115 lb in).