Front Bumper Impact Bar Replacement

Front Bumper Impact Bar Replacement


Removal Procedure

Warning:Refer to Approved Equipment for Collision Repair Warning .

1.Disable the SIR system. Refer to SIR Disabling and Enabling .

2.Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

3.Remove all related panels and components.

4.Repair as much of the damage as possible to factory specifications. Refer to Dimensions - Body .

5.Remove the sealers and anti-corrosion materials from the repair area.

6.Locate and mark all factory welds.





7.Drill all factory welds (1). Note the number and location of welds for installation of the service assembly.





8.Remove the damaged impact bar (1).

Installation Procedure





1.Drill 8 mm (5/16 in) holes for plug welding along the edges of the service panel (1) as noted from the original panel.

2.Clean and prepare the attaching surfaces for welding.





3.Position the impact bar (1) on the vehicle.

4.Verify the fit of the bar.

5.Clamp the impact bar into position.





6.Plug weld accordingly (1).

7.Apply the sealers and anti-corrosion materials to the repair area, as necessary.

8.Paint the repaired area.

9.Install all related panels and components.

10.Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

11.Enable the SIR system. Refer to SIR Disabling and Enabling .