P0966

DTC P0965-P0967

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor
DTC P0965
- Pressure Control Solenoid 2 System Performance

DTC P0966
- Pressure Control Solenoid 2 Control Circuit Low Voltage

DTC P0967
- Pressure Control Solenoid 2 Control Circuit High Voltage

Diagnostic Fault Information






Circuit/System Description

The transmission control module supplies 12 volts to the clutch pressure control solenoid 2 on the high side driver 2 circuit. The transmission control module controls the pressure control solenoid 2 through the clutch pressure control solenoid 2 control circuit. The normally high clutch pressure control solenoid 2 flows fluid to the variable high and 2-3-4 clutch assembly and drive motor 2 when commanded ON. The clutch pressure control solenoid 2 is part of the control solenoid valve assembly and is not serviced separately.

Conditions for Running the DTC

The system voltage is 11-16 V.

Conditions for Setting the DTC

P0965

The transmission control module detects an internal electrical performance malfunction of the clutch pressure control solenoid control circuit for 5 seconds.

P0966

The transmission control module detects an internal low voltage electrical malfunction of the clutch pressure control solenoid control circuit for 1 second.

P0967

The transmission control module detects an internal high voltage electrical malfunction of the clutch pressure control solenoid control circuit for 1 second.

Action Taken When the DTC Sets

* DTC P0965 is a Type B DTC.
* DTCs P0966 and P0967 are Type A DTCs.

Conditions for Clearing the DTC

* DTC P0965 is a Type B DTC.
* DTCs P0966 and P0967 are Type A DTCs.

Reference Information
Schematic Reference

Automatic Transmission Controls Schematics Electrical Diagrams
Connector End View Reference

Component Connector End Views Hybrid/EV Battery Pack X1
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference

Control Module References Programming and Relearning for scan tool information.

Circuit/System Verification

1. Vehicle ON, verify the transmission fluid temperature is between 50-80°C (122-176°F).
2. Drive the vehicle in order to obtain dual motor or dual motor and ICE mode, observe the scan tool Pressure Control Solenoid Valve 2 Performance Test Status parameters. The readings should display OK.

• If the reading is not within the specified range, replace the Q8 control solenoid valve assembly.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Control Module References Programming and Relearning for Control Solenoid Valve Assembly and Transmission Control Module Assembly replacement, programming, and setup.
* Perform the Reset Transmission Adapts Programming and Relearning following all transmission related repairs.