B3567

Driver Information Center Switch Malfunction - DTC B3567

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors
DTC B3567 01
- Info Display Select Switch Circuit Short to Battery

DTC B3567 02
- Info Display Select Switch Circuit Short to Ground

DTC B3567 04
- Info Display Select Switch Circuit Open

DTC B3567 59
- Info Display Select Switch Circuit Protection Time-Out

Circuit/System Description

The driver information center switch is a multiplexed switch. The Select, Back, and Config buttons are a series of momentary contact switches that connect a series of resistors in a resistor ladder format. The Select, Back, and Config buttons utilize a 12 V signal and the instrument cluster determines which button is pressed by the voltage drop across the resistors when the button is pressed.

Conditions for Running the DTC

* The ignition is in OFF, ACCESSORY or RUN position.
* The system voltage is between 9-16 V.

Conditions for Setting the DTC

B3567 01

The instrument cluster detects that the driver information center switch signal circuit is shorted to battery.

B3567 02

The instrument cluster detects that the driver information center switch signal circuit is shorted to ground.

B3567 04

The instrument cluster detects that the driver information center switch signal circuit is open.

B3567 59

The instrument cluster detects that the driver information center switch is stuck.

Action Taken When the DTC Sets

The instrument cluster ignores the driver information center switch inputs.

Conditions for Clearing the DTC

The DTC will become history if the instrument cluster no longer detects a malfunction.

Reference Information
Schematic Reference

Instrument Cluster Schematics Instrument Cluster Schematics
Connector End View Reference

Component Connector End Views Hybrid/EV Battery Pack X1
Description and Operation

Driver Information Center (DIC) Description and Operation Driver Information Center (DIC)
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearning for scan tool information

Circuit/System Verification

Vehicle in Service Mode, observe the scan tool Driver Information Center Switch parameter, that when the S16 driver information center switch, Select, Back, and Config are pressed and released the scan tool parameter toggles between Select, Back, and Config and Inactive.

Circuit/System Testing

1. Vehicle OFF, disconnect the harness connector at the S16 driver information center switch.
2. Test for less than 10 ohm between the low reference circuit terminal 2 and ground.

• If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal replace the P16 instrument cluster.

3. Vehicle in Service Mode, test for 10-12 V between the signal S16 driver information center switch signal circuit terminal 1 and ground.

• If less than the specified range, test the signal for an open/high resistance or a short to ground. If the circuit tests normal replace the P16 instrument cluster.
• If greater than the specified range, test the signal circuit for a short to high voltage. If the circuit tests normal, replace the P16 instrument cluster.

4. If all circuits tests normal, test or replace the S16 driver information center switch.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Driver Information Display and Multifunction Switch Replacement Driver Information Display and Multifunction Switch Replacement
* Control Module References Programming and Relearning for instrument cluster replacement, programming and setup