Front Wheel Drive Shaft Seal Replacement

Front Wheel Drive Shaft Seal Replacement

Tools Required
* J 44385 Differential Bearing Race and Seal Installer
* J 7079-2 Non-threaded Driver Handle
* J 23907 Slide Hammer with Bearing Adapter

Removal Procedure

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the front wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation (Service and Repair).
3. Remove the wheel driveshaft. Refer to Wheel Drive Shaft Replacement (Service and Repair).




4. Use the J 23907 in order to remove the seal.
5. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.

Installation Procedure




1. Use the J 44385 and the J 7079-2 in order to install a new seal. Ensure the seal is seated flush to the outer bore area.
2. Lubricate the seal with transmission fluid. Refer to Lubrication Specifications (Lubrication Specifications).
3. Install the wheel driveshaft. Refer to Wheel Drive Shaft Replacement (Service and Repair).
4. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (Service and Repair).
5. Lower the vehicle.