Spring Bumper Replacement

Spring Bumper Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




2. Lower the rear axle in order to gain access to the top portion of the rear springs. Refer to Coil Spring Replacement (Rear Suspension Coil Spring).




3. Remove the upper spring seat/jounce bumper from the spring, while leaving the lower spring seat on the axle.

Installation Procedure





Important: The rear springs are indexed with the colored tag toward the rear of the vehicle. No up/down or side to side orientation is required.


1. Install the upper spring seat/jounce bumper on the spring.




2. Raise the rear axle in order to seat rear spring. Refer to Coil Spring Replacement (Rear Suspension Coil Spring).
3. Lower the vehicle.