Hydraulic Hose: Service and Repair

Hydraulic Clutch Hose/Pipe Replacement (M86)

Removal Procedure





1. Remove the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .

2. Place a shop towel under the clutch master cylinder and brake master cylinder reservoir in order to catch any additional fluid loss.
3. Disconnect the clutch hose (1) from the clutch master cylinder and brake master cylinder reservoir.
4. Disconnect the clutch line (2) at the clutch actuator cylinder and the transaxle and drain the fluid into a suitable container.



Installation Procedure






Important: Ensure that the clutch line locks securely in place.


1. Connect the clutch line (2) to the clutch master cylinder and the transaxle.
2. Connect the clutch hose (1) to the clutch actuator cylinder and the brake master cylinder reservoir.
3. Remove the shop towel and discard in a suitable container.
4. Install the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
5. Fill the brake/clutch reservoir with DOT 3 hydraulic fluid to the proper fluid level.
6. Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding (Service and Repair) .