Differential Case Assemble

Differential Case Assemble


Tools Required
* 87 92 210 Differential Bearing Support
* J 22919 Differential Side Bearing Installer








Notice: Refer to Fastener Notice .

1. Assemble the differential gear assembly by installing the differential case (320) to ring gear (307) using 12 ring gear-to-case bolts (306).

Tighten the ring gear-to-case bolts to 20 N.m (15 lb ft) plus 90 degrees.
An option for limited slip differential or open differential exists for some models. See inset. Both differential assemblies are serviced only as a complete assembly. The bolts, ring gear and tapered roller bearings are serviceable components.




2. Press the differential bearings onto the differential assembly using the J 22919 (1). Use the 87 92 210 (2) under the differential as shown.
3. To change the differential bearing races, refer to Clutch Housing Assemble (Clutch Housing Assemble) and Transmission Case Disassemble (Transmission Case Disassemble) or Transmission Case Assemble (Transmission Case Assemble) .