FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Backup Lamp Switch: Service and Repair



Backup Lamp Switch Replacement

Removal Procedure

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.


1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
2. Disconnect the backup lamp connector (1).




3. Remove the backup lamp switch assembly.



Installation Procedure

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.







Notice: Refer to Fastener Notice .

1. Install the backup lamp switch using pipe sealant. For the sealant part number, refer to Sealers, Adhesives, and Lubricants (Getrag 5 Speed - Manual Transmission) .

Tighten the switch to 33 N.m (24 lb ft).

2. Connect the backup lamp connector (1).
3. Install the left front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .