Correction

Inspect the tailgate washer hose inside the grommet. If the washer hose is cracked or broken, replace the hose using the following procedure.

1. Inspect the tailgate washer hose inside the grommet. If the hose is cracked, replace the hose.

2. Remove the tailgate trim and the high mount stop lamp.

3. Disconnect the connector and washer hose.

4. Pull out the washer hose and harness assembly from the tailgate. Remove the insulation tape from the harness.

5. Remove the left rear interior "C" pillar trim.

6. Disconnect the washer hose joint.

7. Remove the tailgate washer hose and install a new washer hose using the applicable part number below.

8. If the vehicle has any electrical conditions, inspect for water intrusion into connectors C403 and C404.

^ If washer fluid has penetrated the connectors, clean and dry the terminals.

^ If a wiring harness and connector is damaged, replace the connector. Refer to the Diagnostic information under the Wiring Systems or Wiring Systems and Power Management sub-section.