Shift Control Replacement

Shift Control Replacement

Removal Procedure

1. Remove the console top cover. Refer to Front Floor Console Replacement.
2. Remove the shift cables from the shifter assembly. Refer to Shift Cable Replacement.




3. Remove the 2 front mounting nuts (2).
4. Remove the 2 rear mounting nuts (3) and the shifter.

Installation Procedure




1. Position the shifter on the studs and install the front 2 nuts (2).

Notice: Refer to Fastener Notice.

2. Install the 2 rear nuts (3).

Tighten the nuts to 25 N.m (18 lb ft).

3. Install the shift cables. Refer to Shift Cable Replacement.
4. Install the console. Refer to Front Floor Console Replacement.