Battery Negative Cable Replacement (Battery to Battery Tray)

Battery Negative Cable Replacement (Battery to Battery Tray)

Removal Procedure

Important:
* Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.

* Always route the replacement cable the same way as the original cable.




1. Disconnect the negative battery cable.
2. Disconnect the body harness electrical connector (7) from the battery current sensor (6).
3. Remove the negative battery cable ground bolt (4).
4. Separate the negative battery cable terminal (5) from the battery support.
5. Remove the negative battery cable (3).

Installation Procedure




1. Install the negative battery cable (3). Ensure that the anti-rotation tab on the terminal (5) is correctly located.

Notice: Refer to Fastener Notice.

2. Install the negative battery cable ground bolt (4).

Tighten the bolt to 17 N.m (13 lb ft).

3. Connect the body harness electrical connector (7) to the battery current sensor (6).
4. Connect the negative battery cable.