Manifold Absolute Pressure Sensor Replacement (TMAP)

Manifold Absolute Pressure Sensor Replacement (TMAP)

Removal Procedure




1. Disconnect the temperature manifold absolute pressure (TMAP) sensor harness connector.
2. Remove the TMAP sensor from the intake manifold.

Important: If the TMAP sensor seal is damaged, the TMAP sensor must be replaced.

3. Inspect the seal for damage.

Installation Procedure






Notice: Refer to Fastener Notice.

Important: Use the new TMAP sensor seal provided with the new TMAP sensor.

1. Install the TMAP sensor into the intake manifold.

Tighten the bolt to 10 N.m (89 lb in).

2. Connect the TMAP sensor harness connector.