Powertrain Mount Balance - Lower Mount

Powertrain Mount Balance - Lower Mount

Important: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.




2. Loosen the front transmission mount through bolt. Do not remove.




3. Loosen the rear transmission mount through bolt. Do not remove.
4. Shake the powertrain vigorously from front to rear and allow powertrain to settle.

Notice: Refer to Fastener Notice.

5. Tighten the rear transmission mount through bolt.

Tighten the bolt to 100 N.m (74 lb ft).




6. Tighten the front transmission mount through bolt.

Tighten the bolt to 100 N.m (74 lb ft).

7. Lower the vehicle.