Brake Light Switch: Service and Repair

Stop Lamp Switch Replacement

Removal Procedure





Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Disconnect the stop lamp switch from the plug connector.
3. Turn the switch. Remove the switch from the brake pedal bracket.

Installation Procedure




1. Place the stop lamp switch into the plug connector.
2. Twist the stop lamp switch into the brake pedal bracket hole.
3. Depress the brake pedal and pull the switch plunger to its maximum setting to adjust the switch.
4. Release the plunger and pull up on the pedal.
5. Connect the negative battery cable.