64. Camshaft Cover Installation

Camshaft Cover Installation





1. Assemble the camshaft cover and gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the cover on the cylinder head and hand start the bolts.
^ Tighten the camshaft cover bolts to 10 Nm (89 inch lbs.).





3. Install the front lift bracket.
4. Install the front lift bracket bolt.
^ Tighten the bolt to 25 Nm (18 ft. lbs.).





5. Install the rear lift bracket.
6. Install the rear lift bracket bolts.
^ Tighten the bolts to 25 Nm (18 ft. lbs.).





7. Install the spark plugs.
^ Tighten the spark plugs to 20 Nm (15 ft. lbs.).





8. Install the ignition coil.
^ Tighten the ignition coil bolts to 10 Nm (89 inch lbs.).
9. Install the camshaft position actuator solenoid valves.
10. Install the camshaft position actuator solenoid valve bolts.