M86

Clutch Drive Plate and Clutch Driven Plate (M86)

^ Tools Required
- J 43482 Clutch Alignment Arbor

Removal Procedure

1. Remove the transmission.





2. Remove the clutch cover bolts one turn at a time, until spring pressure is relieved.





3. Remove the clutch cover and the clutch disc.

Installation Procedure





1. Align the Heavy Side of the flywheel assembly , with the clutch cover Light Side.





2. Install the J 43482 in order to support the clutch cover to the flywheel assembly.





Notice: Refer to Fastener Notice in Service Precautions.

3. Install the clutch cover to flywheel bolts.

^ Follow the tightening sequence. Tighten the bolts to 24 Nm (18 ft. lbs.).
4. Remove the J 43482.

Important: Excessive amounts of lubricant on the input shaft splines may contaminate the clutch disc and cause clutch shudder.

5. Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
6. Install the transmission.
7. Bleed the hydraulic system.
8. Connect the negative battery cable.