Camshaft Bearing

Camshaft Bearing Cap bolts
Tighten the camshaft bearing cap bolts in increments of three turns until they are seated, lubricate. Tighten the camshaft bearing caps to 10 Nm (89 inch lbs.)





Rear Intake Camshaft Bearing Cap bolts
Apply Permatex Anaerobic Gasket Maker 51813, 3.5 mm (0.138 inch) bead, to rear intake camshaft bearing cap.

Install the rear intake camshaft bearing cap bolts.
Tighten the bolts to 25 Nm (18 ft. lbs.)