Manifold Absolute Pressure (MAP) Sensor Replacement (SCIP)

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT (SCIP)

REMOVAL PROCEDURE




1. Disconnect the supercharger inlet pressure (SCIP) sensor harness connector.
2. Remove the SCIP sensor (1) from the supercharger.
3. Inspect the seal for damage.

IMPORTANT: If the SCIP sensor seal is damaged, the SCIP sensor must be replaced.

INSTALLATION PROCEDURE




1. Install the SCIP sensor (1) into the intake manifold.

NOTE: Refer to Fastener Notice in Service Precautions.

IMPORTANT: Use the new SCIP sensor seal provided with the new SCIP sensor.

Tighten the bolt to 10 N.m (89 lb in).

2. Connect the SCIP sensor harness connector.