Air Temperature Actuator

AIR TEMPERATURE ACTUATOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the fuse labeled HVAC CTRL (BATT).
2. Remove the steering column filler panel.




3. Disconnect the air temperature actuator electrical connector.




4. Remove the air temperature actuator screws.
5. Remove the air temperature actuator.

INSTALLATION PROCEDURE




1. Install the air temperature actuator.

IMPORTANT: The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.

2. Install the air temperature actuator screws.

Tighten the screws to 2.2 N.m (19 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.




3. Install the air temperature actuator electrical connector.
4. Install the steering column filler panel.
5. Install the fuse labeled HVAC CTRL (BATT).
6. Start the engine and let run for one minute.

IMPORTANT: Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.