Powertrain Mount Balance - Lower Mount

Powertrain Mount Balance Procedure - Lower Mount

Important: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.

1. Raise and support the vehicle.





2. Loosen the front transmission mount through bolt. Do not remove.





3. Loosen the rear transmission mount through bolt. Do not remove.
4. Shake the powertrain vigorously from front to rear and allow powertrain to settle.

Notice: Refer to Fastener Notice in Service Precautions.

5. Tighten the rear transmission mount through bolt.
^ Tighten the bolt to 100 Nm (74 ft. lbs.).





6. Tighten the front transmission mount through bolt.
^ Tighten the bolt to 100 Nm (74 ft. lbs.).
7. Lower the vehicle.