Gearshift Control Lever Replacement

Gearshift Control Lever Replacement

Removal Procedure





Caution:
Refer to Battery Disconnect Caution Battery Disconnect Caution in Cautions and Notices.

Notice:
Refer to Transmission Selector Shaft Abuse Notice Transmission Selector Shaft Abuse Notice in Cautions and Notices.

1. Disconnect the negative battery cable.

2. Remove the floor console. Refer to Front Floor Console Replacement Service and Repair in Instrument Panel, Gauges, and Console.

3. Disconnect the wiring harness connectors from the shift control lever.





4. Loosen the control cable adjusting nut.

5. Disconnect the control cable from the shift control lever assembly.





6. Remove the shift control lever assembly mounting bolts.

7. Remove the shift control lever assembly.

Installation Procedure





Notice:
Refer to Fastener Notice Fastener Notice in Cautions and Notices.

1. Install the shift control lever assembly and mounting bolts.

Tighten the shift control lever assembly mounting bolts to 8 Nm (71 lb in).





2. Connect the control cable to the shift control lever assembly.

3. Tighten the control cable adjusting nut.

Tighten the control cable adjusting nut to 8 Nm (71 lb in).





4. Connect the harness connector.

5. Adjust the control cable. Refer to Range Selector Lever Cable Adjustment Aisin 81-40LE - Automatic Transmission.

6. Install the floor console. Refer to Front Floor Console Replacement Service and Repair in Instrument Panel, Gauges, and Console.

7. Connect the negative battery cable.