MU3

Shift Control Cable Replacement

Removal Procedure

1. Apply the parking brake.
2. Shift the transmission to 4th gear.
3. Remove the console.





4. Lift up the cable retainers.
5. Disconnect cable ends from the shift control assembly, noting the location for assembly.





6. Disconnect the cable ends (1) from the transmission shift levers, noting the location for assembly.
7. Remove the shift cable (2) from the transmission cable bracket.
8. Raise and support the vehicle. Refer to Vehicle Lifting
9. Remove the shift cable attachment nut from the underbody.
10. Lower the vehicle.
11. Remove the left instrument panel closeout panel.
12. Position the drivers side front carpet aside.





13. Separate the grommet (1) from the floor pan.
14. Remove the cable from the vehicle by pulling the cables through the drivers floor opening.

Installation Procedure
1. Feed the cable assembly through the drivers floor opening.





2. Install the grommet (1) flush with the floor opening.
3. Install the drivers side front carpet.
4. Install the left instrument panel closeout panel.
5. Raise the vehicle.

6. Notice: Refer to Fastener Notice in Service Precautions.

Install the shift cable attachment nut to the underbody.
^ Tighten the nut to 10 Nm (89 inch lbs.).
7. Lower the vehicle.
8. Install the shift cables (2) to the transmission cable bracket.





9. Connect the shift cable ends (1) to the transmission shift levers as noted during disassembly.
10. Connect the shift cable to the shift control assembly as noted during disassembly.





11. Push the shifter 4th gear locking tab.
12. Ensure that the transmission is in 4th gear.





13. Press down on the locking tabs.
14. Pull the shifter 4th gear lock clip to its original position.
15. Install the console.