14. Clutch Housing Assemble

Clutch Housing Assemble

^ Tools Required
- 83-90-114Sleeve
- 83-90-312 Drift, Bearing Race Input Shaft
- 87-91-311 Sleeve, Bearing Driver Shaft
- 87-92-210 Support, Differential Bearing
- 87-92-236 Support
- J 44809 Output Shaft Seal Installer





1. Press in the new differential bearing race using the J 44809. Use the 87-92-236 as a base for the pressing operation.





2. Install the new axle using the J 44809.





3. Press in the new input shaft bearing race using the 83-90-312 (1). Use the 83-90-114 (2) and the 87-91-311 (3) as a base for the pressing operation.