MU3

Axle Seals Replacement

^ Tools Required
- SA9133T Axle Seal Puller

Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting
2. Remove the front wheel and tire assemblies.
3. Remove the wheel driveshaft or intermediate drive shaft.





4. Use the SA9133T in order to remove the seal.
5. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.

Installation Procedure





1. Use the SA9133T to install a new seal. Ensure that the seal is seated flush to the outer bore area.
2. Install the wheel driveshaft or intermediate drive shaft.
3. Install the front tire and wheel assemblies.
4. Lower the vehicle.