Battery Current Sensor: Service and Repair

BATTERY CURRENT SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the battery current sensor electrical connector (2).
2. Remove the battery negative cable from the vehicle.
3. Remove the tape (3) securing the battery current sensor (1) to the negative battery cable (4).




4. Remove the battery current sensor (2) from the ground end of the negative battery cable (1).

INSTALLATION PROCEDURE




1. Install the battery current sensor (2) by passing the ground end of the negative battery cable (1) through the sensor. Slide the current sensor to the battery end of the cable in order to encompass all ground wires attached to battery.




2. Wrap electrical tape (3) around the battery current sensor (1) in order to secure the battery current sensor to the negative battery cable (4).

IMPORTANT: Ensure the battery current sensor is installed in the correct direction and location on the negative battery cable. Also ensure that ALL grounding wires connected to negative post of battery pass through the sensor.

3. Install the battery negative cable to the vehicle.
4. Connect the battery current sensor electrical connector (2).