67. Camshaft Cover Installation

Camshaft Cover Installation





1. Assemble the camshaft cover and gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the cover on the cylinder head and hand start the bolts.
^ Tighten the camshaft cover bolts to 8 Nm (71 inch lbs.).





3. Install the spark plugs.
^ Tighten the spark plugs to 20 Nm (15 ft. lbs.).





4. Install the ignition coil and module assembly to the cam cover.
^ Tighten the ignition coil and module assembly bolts to 8 Nm (71 inch lbs.).





5. Install the ignition coil cover.
^ Tighten the cover to 8 Nm (71 inch lbs.).





6. Install the lift hook.
^ Tighten the hook to 22 Nm (16 ft. lbs.).





7. Install the camshaft position sensor.
^ Tighten the sensor to 8 Nm (71 inch lbs.).





8. Install the power steering blockout plate.
^ Tighten the power steering blockout plate bolts to 25 Nm (18 ft. lbs.).